Foil hydroprinting personalized.
Width: 60 cm.
Length: 100cm each unit (example: 3pcs = 300cm)
Packaging and shipping conditions: The film is rolled up and then placed in a plastic bag that avoids contamination with humidity and dirt. Silica gel bags are included for greater anti-humidity efficiency. The set is shipped in a reusable cardboard cylinder with plastic caps.
Special indications for use:
1) Unroll the foil on a dry table
2) Peel the foil from the support
3) Place the face that was glued on the support in contact with the water
4) Wait 60 seconds for the sheet to hydrate at 25ºC
5) Apply one pass of activator (less than a normal hydroprint sheet)
6) Wait 20 seconds until the sheet liquefies perfectly
7) Immerse the piece to be decorated more slowly than if it were a normal hydro-printing sheet. In addition, ensure that the sheet does not stretch, being the piece the one that always approaches the sheet and not the other way around.
make square meter sheet available again